I am hopping to found MAC user with similar mount on that forum that have successful connection. Without success too.Īlso, should I also connect the USB-serial controller D ("System Preference>Network>USB/SERIAL Controller>Connect) before I start to connect the mount with the indi serve ? In that case, I received a message box which say that the periferic isn't responding.
I initiate the connection (int the INDI control Panel application) and it failed. Similarily, on the INDI panel control, I set up the Baud rate to 9600 too. Select “Tone” for dialing and “on” for sound. Un-tick “enable error correction and compression in modem”. In other world, the Network USB/Serial controller was configured as :ĭial mode = ignore dialtone when dialling. I configured this new connection following the recommandation " c./plugable/topics/os.-connection-solution.
MAC USB SERIAL DRIVER DRIVER
The application recognised the cable has an "USB serial D controller" and I installed the driver PL2303 from prolific ( The installation of the driver created a new "network connection" called USB-Serial Controller D.
Has the cable was not recognised by the OS Sierra, I used the Serial Detect Application ( to identify the driver I needed to instal. The connection is done with Skywatcher SYNSCAN USB to SERIAL cable, connected to the SerialRJ11 (delivered with the mount) which is itself connected to the hand control of the mount. I try to "connect" the mount, using the "INDI Control Panel" application, I receive a message saying "Mount not Responding" and I can't establish the dialog.
0 kommentar(er)
